Cypress CTM-132 Manual do Utilizador descarregar pdf (Página 270)

• When sending power up reports locally/remotely, power up reports will be stored on the CTM-200 until a signal is obtained. For the stored reports to

be sent, the following conditions must be met:

• the CTM-200 must obtain a signal

• (Only applies to firmware below 3041) The same report number(s)(r1 to r8) used in cmd pupreport must be used in another command (ie

obdreport, vccreport)

• (Only applies to firmware below 3041) The 'other' command (ie. [obdreport], [vccreport]) must be sending live data

Examples:

1. Configure reports #2 and #999 for power-up trigger condition #1 :

cmd pupreport 1 2 999

Cypress CTM-132 Manual do Utilizador Página 270

Comentários a estes Manuais