Cypress CTM-132 Manual do Utilizador descarregar pdf (Página 215)

WikiPrint - from Polar Technologies

215

mode a b c

Sets the required functionality of the serial ports.

a The function of ttyAM0 (Primary DB9) (port 1)

b The function of ttyAM1 (Secondary DB9) (port 2)

c The function of ttyAM3 (RS485) (port 3)

Mode Serial Port Function

1 None

2 Console

3 PPP

4 PAD host interface

6 MODBUS host interface

9 Magnetic Card Reader interface

10 WPAN Gateway

12 Chlorobyte Spreader Controller interface

13 external GPS receiver

15 Epomaster Spreader Controller interface

17 Garmin mode - client/server

18 Garmin mode - client only

19 Garmin mode - server only

20 WPAN PAD client loopback

21 Diagnostic passthrough

22 Auxiliary device support

Auxiliary device support (polling device, e.g. Bosch Spreader, Dickey John

Salt Spreader)

24 Auxiliary device support (non-polling device, e.g. Parker Spreader)

Notes:

• default is cmd mode 2 0 0

• ttyAM2 is used for STM communication.

To escape out of the mode (to get a command prompt ? console) do the following:

• mode = 3 ? type EXIT, type cmd port n bbbb (where n is the serial port number and bbbb is the current baud rate)

• mode = 4 ? type +++, wait 3 seconds, type cmd port n bbbb (where n is the port number and bbbb is the current baud rate); Refer to [pad esc]

and [pad esct] for escape sequence

Examples:

1. Set primary serial port to use PAD :

cmd mode 4 0 0

1. Set primary serial port to use Console, and secondary serial port to use PPP :

cmd mode 2 3 0

1. Set primary serial port to use Console, and secondary serial port to use client mode connection for external Garmin communications :

cmd mode 2 18 0

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 399 400

Cypress CTM-132 Manual do Utilizador Página 215