Cypress CTM-132 Manual do Utilizador descarregar pdf (Página 262)

100

101

WikiPrint - from Polar Technologies

262

pendantreport r1 [r2] [r3] [r4] [r5] [r6] [r7] [r8]

This command sets the general report(s) to be used for pendant triggered reports. Pendant reports are triggered by any message received from the

Pendant including ON and OFF messages.

Up to 8 reports can be assigned to the pendantreport.

r = 0 Disables the report (Default)

r = 1 to 999 Report number

Notes:

• this command requires the modem to be listening for traffic from the WPAN gateway, this requires cmd mode 10 to be configured if using external

WPAN gateway

• Pendant report is triggered by any message received from the Pendant. The following message is appended to the report:

$PPEN,ID,SEQ,MES*CHKSUM

ID - 64 bit unique hex ID of Pendant

SEQ - Packet sequence number

MES - Pendant message payload

CHKSUM - NMEA message checksum

Example:

$PPEN,0013A200402CB498,17,PANIC*07

Examples:

1. Use report 1 for pendant triggered reports :

cmd pendantreport 1

See also: [Down Pendant], [General Reports]

The format of this command has changed from R1.2.0 to R1.2.1. R1.2.0 allowed a single report, whereas up to 8 reports can now be configured.

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 399 400

Cypress CTM-132 Manual do Utilizador Página 262

Comentários a estes Manuais