Cypress CSC-5300 Manual do Utilizador descarregar pdf (Página 17)

10 Chapter 2: Installation

Calorimetry Sciences Corp.

CSC 5300 N-ITC III 11

User’s Manual

5300 icon located on the desktop or by going to Start⇒Programs⇒CSC 5300. After

the software starts set the temperature to 25.0°C and let the system equilibrate for

approximately 1 hour to allow the internal electronics to warm up.

Select the “Monitor” tab to display the virtual strip chart. Heat readings (μJ/sec) slowly

scroll across from the right side of the screen. The N-ITC III is now ready for use.

Reinstalling Software

The software for your N-ITC III was previously installed at the factory. However, a set of

software installation disks are included in the event you need to reinstall the software.

1. Insert N-ITC III software CD in the CD-ROM drive.

2. Select Start⇒Run.

3. In the Run dialog box type D:\Setup.exe, or browse to locate the appropriate setup

le, and click OK.

4. Follow the on-screen prompts as indicated.

5. When the software installation process is complete, a prompt may appear indicating

you need to restart your computer. If this prompt appears then software installation is

not complete until you restart your computer system.

Installation of the N-ITC III software is now complete.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

Sem comentários

Cypress CSC-5300 Manual do Utilizador Página 17