Cypress Chameleon CTM-15X Manual do Utilizador descarregar pdf (Página 9)

Chameleon Serial Upgrade Utility Notes

(Revision 1.4)

9 4BOperation

• Creating FreeSpace partition (R1.2.X and below only)

• Setting fconfig (FCONFIG Update only)

• Rebooting modem

• Upgrade complete

If an error occurs anywhere in the upgrade procedure, the Chameleon Serial Upgrade utility will display

an error message pop-up and the Status field will display “Update unsuccessful”.

When the upgrade has completed successfully, a notice will be displayed and the Chameleon Serial

Upgrade utility will power cycle the modem.

When the upgrade process is complete, the Serial Port Settings will display “DISCONNECTED” and the

Status field will show “Upgrade complete”. Click the Quit button to close the Chameleon Serial Upgrade

utility.

Step 7: Use serial console to verify upgraded firmware version, factory reset, and

save configuration

After the modem power cycles, the modem must be configured once via the serial console with the

factory default settings and then saved.

With the device powered up and connected directly to a PC with a serial cable, start up a terminal

emulation program such as Windows HyperTerminal or similar application and select the corresponding

COM port.

Configure the terminal emulation program with the following parameters:

• Data rate: 115,200 baud

• Data bits: 8

• Parity: None

• Stop bits: 1

• Flow control: None

Note: The above settings are the device default settings

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Cypress Chameleon CTM-15X Manual do Utilizador Página 9