Cypress Chameleon CTM-15X Manual do Utilizador descarregar pdf (Página 10)

Chameleon Serial Upgrade Utility Notes

(Revision 1.4)

10 4BOperation

IMPORTANT - PLEASE PERFORM THIS STEP

For firmware upgrades from R1.2.X to R1.3.X and above, the modem must be left powered on for 5

minutes to complete the firmware upgrade. After 5 minutes, the following verification steps must be

done before factory resetting the modem:

• Press the Enter key to return the / # prompt.

• Verify that the firmware upgrade is complete by entering the command: df

• In the output of the df command, verify that the following highlighted line is present:

To verify the upgraded firmware version, enter the command: cmd ver

For upgrades to firmware versions below R1.3.0.1705 including R1.1.X and R1.2.X:

• To factory reset a modem, enter the command: cmd factory

• To save the factory settings, enter the command cmd save

For upgrades to firmware versions R1.3.0.1705 and above:

• To factory reset an EVDO modem, enter the command: cmd factory full

• To factory reset an HSPA+ modem, enter the command: cmd factory full gsm

• To factory reset a wi-fi modem, enter the command: cmd factory full wifi

• The factory settings will be saved at the end of each of the above commands.

You have successfully completed the firmware upgrade. Now, you can reconfigure your modem using any

method of your choice:

• Serial console

• Telnet

• Web

• SSH (R1.3.X and above only)

• ULCP Download Script Files message (R1.3.X and above only)

• cmd confupgrade issued from serial console, Telnet, SSH, or ULCP Download Script Files message

1 2 ... 5 6 7 8 9 10 11

Sem comentários

Cypress Chameleon CTM-15X Manual do Utilizador Página 10