Cypress 7C185-20 Guia do Utilizador descarregar pdf (Página 19)

Cedar 880AG Dual-Radio AP/Bridge

Figure 3.2 Scan Tool Configure IP Screen

6. The administrator can assign a static IP address to the AP by :

a) Change IP address mode to static

b) Enter IP address, subnet mask and gateway IP address.

c) Provide the SNMP read/write community name in order to make any

configuration change. The Cedar initial SNMP read/write community name is

private.

7. You can also use Scan Tool to upgrade the AP firmware by clicking the Upgrade tab:

a) Select either FTP or TFTP protocol.

b) Enter server IP address, firmware name and optional FTP login name and

password.

c) Provide the SNMP read/write community name. The Cedar initial SNMP

read/write community name is private.

8. In case SNMP, telnet or web interface are accidentally turned off, Scan Tool can be

used to turn them back on again by clicking the Advanced tab.

) Intelicis Scan Tool scans Intelicis access points only. It does not scan access points

from other manufactures.

) Please run one instance of Scan Tool on a network. Running multiple instances may

receive incorrect scan result.

3.2 Default Setting

Table 3.1 lists Cedar’s manufacturer default settings:

Default login name admin

Default login password changeitnow

Default enable password changeitnow

Default IP address Acquired from the DHCP server.

Default subnet mask Acquired from the DHCP server.

Default gateway Acquired from the DHCP server.

Default DNS IP address Acquired from the DHCP server

Default management VLAN ID Untagged

Default SSID for Radio 1 Intelicis-a

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 108 109

Sem comentários

Cypress 7C185-20 Guia do Utilizador Página 19