Cypress 7C185-20 Guia do Utilizador descarregar pdf (Página 16)

Cedar 880AG Dual-Radio AP/Bridge

2.3.3 Supplying Power to the Unit

The Indoor Cedar 880AG is equipped with a universal 100-240 VAC, 50/60 Hz power

supply. To power the unit, connect the included power adaptor to the wall outlet and plug

the DC output connector into the power jack on the rear panel of Cedar 880AG.

Cedar 880AG also supports the 802.3af PoE standard. If your switch or gateway has the

capability to supply PoE to remote devices, simply connect the Ethernet cable from your

switch or gateway to the RJ45 connector on the rear panel of Cedar 880AG. This will

automatically supply power to the unit.

2.4 Connecting Cedar 880AG (Indoor AP only)

To establish a connection to Cedar’s console interface, you will need to:

• Connect a regular straight serial cable to the console port located on the rear panel of

the unit.

• Connect the other end of the serial cable to a terminal or PC.

After the unit is turned on, the LEDs on the top panel will follow the pattern described

below:

• The Power LED goes on.

• The Ethernet LED will be ON if the Ethernet port is connected to a switch or gateway

and a valid link is established.

• After 30 seconds, the 802.11a and 802.11g LEDs will be flashing.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 108 109

Sem comentários

Cypress 7C185-20 Guia do Utilizador Página 16