Cypress CWHDI-RX Especificações descarregar pdf (Página 6)

① Power: Press to turn the system on/off.

② ID: Press transmitter “ID” button and receiver “ID” button for 2 second to

connect the system. The system was already connected before leaving the

factory, so users do not need to reset it unless the system cannot up link

properly. Press

4.2.2 Rear Panel

① HDMI output: Connect the HDMI output to the HDMI input of your display

using an HDMI cable.

② HDMI output: Connect the HDMI output to the HDMI input of your display

using an HDMI cable.

1 2

HDMI OUT

DC 5V

the ID button for more than 10 seconds to switch to a different mode

(Broadcast/Unicast). When the LED is green it means switch to Unicast mode

and when it is Red, it means switch to Broadcast Mode. The factory default is

Unicast mode and it is suggested to use this mode for household use. It is not

necessary to press both the transmitter and receiver's ID buttons at the same

time.

③ IR sensor.

④ Power: The LED will switch on when power is ON.

⑤ Link: When the system is in search mode the LED will flash repeatedly, and

when in link mode the LED will slowly flash. When the LED does not flash it

means a link has been successfully established.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Cypress CWHDI-RX Especificações Página 6