Cypress CWHDI-RX Especificações descarregar pdf (Página 9)

7. Operation Controls and Functions

The following sections describe the hardware components of the unit with

installation guide and setting methods.

7.1 Transmitter

7.1.1 Front Panel

①

IR sensor

②

480i

→

480p / 576i

→

576p LED indicator and INPUT -



P/5SEC button: Press this button to select the input

source from COMP1 to PC or press for 5 seconds to

switch between interlace and progressive format,

yellow LED light will turn on when switched from

interlace to progressive format, when switching

from progressive to interlace the light will not turn

on.

③

Input source selection: Press the input button to

switch to your desired input sources from PC to

COMP1, green LED will illuminate according to your

selection.

④

Link LED: When the system is in search mode the

blue LED will flash repeatedly, and when it is in

signal linking mode it will slowly flash. When the LED

is on and there is no flashing it means the system is

ready and audio or video can be sent.

⑤

ID: Press this button with the receivers

“

”

button

for two seconds to connect the systems. Before

they left the factory the systems were already

connected so there is no need for the user to

reset the connection unless the systems cannot

link up properly. Press the ID button for more than

ten seconds to switch between Broadcast and

Unicast mode. When the green LED is on it means

the system is in Unicast mode and when the Red

LED is lit the system is in Broadcast mode. The

default mode for this system is Unicast and it is

recommended to use this for home use. It is not

necessary to press both the transmitter and receiver

buttons at the same time.

Note:

Due to the nature of Broadcast mode, which

has no uplink, there can be no communication

between Transmitter and Receiver, the result is the

following:

• HDCP protected content should not be

transmitted.

• CEC and EDID repeater functions cannot be

supported.

• Broadcast mode is not HDCP compliant.

• Only supports single transmitter link with multiple

receivers.

⑥

Power: The LED will illuminate when power is on.

②

③

④

⑤

⑥

POWER

INPUT+

HDMI

COMP

VIDEO

2 1

480i



480p

576i



576p

S-VIDEO

LINK

INPUT



P/5SEC

POWER

①

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentários a estes Manuais

Sem comentários

Cypress CWHDI-RX Especificações Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor Cypress CWHDI-RX